Bus-Profi Forum

Hello Piotr,
the old syntax works....

The problem makes the new syntax...

If set in the Pro from module 5 the sendkey command to the Base with a5 hit....

And under events in the base wrote

E.LCN.key.0.5.A5
hit

It doesn´t work ....
If I go over the thresholds and do the sendkeys when a threshold is reached, it works.....

New syntax doesn't make any problem. If you test it from the LCN-Pro then the send-key command will be seen by Base as a command sent from LCN-Pro, not from LCN module. But try (just for testing) to bind send-key command to any phisical key and then press this key. Then you will see that the event actually works:)

That is what I did the whole evening

I will check again and then I will make some screenshots....

Obviously you did something wrong. I tested it and I'm sure it works properly.

Funktioniert bei mir ebenfalls einwandfrei, sowohl die alte als auch die neue Syntax...

Kannst Du mal einen Mitschnitt des Pro Monitors posten?

Funktioniert jetzt

Habe allerdings vorher das Base von 1.8.1.1 auf 1.8.2.0 geupdated....

Vielleicht lag es daran....