Sende Taste an Base

[koboldo]

Hello Piotr,
the old syntax works....

The problem makes the new syntax...

If set in the Pro from module 5 the sendkey command to the Base with a5 hit....

And under events in the base wrote

E.LCN.key.0.5.A5
hit

It doesn´t work ....
If I go over the thresholds and do the sendkeys when a threshold is reached, it works.....

[DOMIQ-Support]

New syntax doesn't make any problem. If you test it from the LCN-Pro then the send-key command will be seen by Base as a command sent from LCN-Pro, not from LCN module. But try (just for testing) to bind send-key command to any phisical key and then press this key. Then you will see that the event actually works:)

[koboldo]

That is what I did the whole evening

I will check again and then I will make some screenshots....

[DOMIQ-Support]

Obviously you did something wrong. I tested it and I'm sure it works properly.

[Wowbagger]

Funktioniert bei mir ebenfalls einwandfrei, sowohl die alte als auch die neue Syntax...

Kannst Du mal einen Mitschnitt des Pro Monitors posten?

[koboldo]

Funktioniert jetzt

Habe allerdings vorher das Base von 1.8.1.1 auf 1.8.2.0 geupdated....

Vielleicht lag es daran....