Problem with LCN-AVN

[edubht]

Hello
I have several AVN LCN-connected to the analog outputs of several SH.
The outputs are configured as a dimmer and linear.
The problem is to open 100% analog outputs, or use a regulator with ts. The LCN-AVN not make any movement. The upper cylinder is immobile.

[Chris]

Hello,

test the AVM as switch. After you switch the avn on you must wait 2minutes. After the 2minutes the valve has open. Please test and contact me.

Best regards

Chris

[rk]

Hello,
at first our obligatory warm welcome to a new Bus-Profi member .

I'm not sure if you see the "first open function" and description in the blurb or in german "Waschzettel". Look at the pictures on page 4. Sorry, i didn't find an English version.

Is the valve open? Did you see the indicator extended?
If so, you've been waiting for at least 6 minutes?

[edubht]

Thanks chris and Rk.

The avn as switch, opens and closes to disconnect.

But with SH don't move, I waited more than 6 minutes and nothing happens.

The configuration dimmer-lineal is correct?

Attached image.
[img]1[/img]

[Uwe]

Hello - and WELCOME from me too

The configuration dimmer-lineal is correct?

No - not for the AVN ...
Try it with PPS in the Output Settings

[img]1[/img]

The installation instructions are in English not available. I have several translations available (unfortunately not all modules). You need it? Send me a mail ...

Best regards
Uwe

[Beleuchtfix]

Hi and welcome to the Bus-Profi Club

The design asks for a setup in PPS -mode. You do have to set the pps-time also, 300 seconds at the beginning is a good start.
PPS coresponds to ppc in the English language.

[img]1[/img]

Regards Florian

[LuckyLPA]

Hello.

Please check the voltage on output too. Make sure the output´s not defect.

greetings

PS: Number 2 and 3 looks like "first-open-mode"

[edubht]

Thanks.

Uwe, Installation instructions are not necessary.

I think it's scheduling problems.

Carsten, outputs are working properly.

I will try with pps and 300sec. Now I will tell you.

And char table has to be linear?

Best regards.

[Uwe]

¡Hola

linear / halogen ... it does not matter - PPS (PPC), the signal pulses ...

buena noche
Uwe

[edubht]

Good evening friends.

After trying with PPC, the AVN continue without making any movement.

I'm waiting for the installer to check the installation. Could it be some other reason?