Seite 1 von 1
#1 Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 19:27
von norden
Moin,
es gibt ein neues Update für das BASE
[img]1[/img]
[img]2[/img]
#2 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 20:41
von Thomas
HM...
20:40:10 INF SRV.INT COMMAND Unknown command LCN.variable.0.8.11=1070, try help.
20:40:10 INF SRV.INT COMMAND Unknown command LCN.variable.0.8.12=1002, try help.
20:40:11 INF SRV.INT COMMAND Unknown command LCN.variable.0.8.11=1102, try help.
20:40:11 INF SRV.INT COMMAND Unknown command LCN.variable.0.8.12=1054, try help.
20:40:12 INF SRV.INT COMMAND Unknown command LCN.sensor.0.20.5=0, try help.
#3 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 20:52
von Thomas
NICHT aufspielen !!!!!
#4 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 20:54
von DOMIQ-Support
Thomas as far as I know there are no commands to set LCN variables through LCN.variable identifiers as they are read-only:) The same with LCN.sensor. This new update didn't touch anything related to LCN, only serial modules as you can see new elements in the configurator.
#5 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 20:58
von Thomas
Hi Piotr,
bin am testen, komische Meldungen im LOG...
gleich geht es weiter...
#6 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 21:07
von Thomas
Alles gut,
update ist durch das TESTMODUL "DOMIQ LIGHT beta" fehlgeschlagen zu sein,
und die Meldungen verursacht zu haben.
bus4 = AD 0.10
fliegt jetzt sofort raus...
#7 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 21:17
von Thomas
This new update didn't touch anything related to LCN, only serial modules as you can see new elements in the configurator.
Das glaube ich jetzt nicht, da ich wieder was anderes sehe,
@Florian, schaue mal bei dir !
lg Thomas
#8 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 22:01
von norden
Moin Thomas,
ich habe auf 3 BASE das Update eingespielt, bei allen keine Auffälligkeiten mit Ausnahme der Erweiterungen im WEB Interface
Gruß
Dieter
#9 RE: Neues Update für das BASE!
Verfasst: Do 29. Mai 2014, 23:42
von Beleuchtfix
Bei mir sieht es auch ok aus.
Gruß
Florian